ISO/DIS 13715-2014 pdf free.Technical product documentation – Edges of undefined shape – Indication and dimensioning. ISO/DIS 13715 specifies rules for the indication and dimensioning of undefined edges in technical product documentation.The proportions and dimensions of the graphical symbols to be used are also specified. NOTE The undefined edge can only he specified in 21) drawings. In cases where the geometrically defined shape of an edge (for example 1 x 450) is required, the general dimensioning principles given in ISO 129-1 apply. 2 Normative references The following document, in whole or in part, is normatively referenced in this document and is indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 3098-0:1997, Technical product documentation — Lettering — Part 0: General requirements 3 Terms and definitions edge of undefined shape transition line, included in an intersection plane, which is not defined on the nominal model and which exists between two adjacent integral surfaces burr roughremainderofmaterialoutsidetheidealgeometrical shapeofanexternaledge,residueofmachiningorofa formingprocess NOTE 1 Examples arc presented in Figure 1. NOTE 2 A burr Is an unwanted but often an unavoidable defect. 3.3 undercut deviation inside the ideal geometrical…

ISO 129-5-2018 pdf free.Technical product documentation – Indication of dimensions and tolerances – Part 5: Dimensioning of structural metal work. The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 129-1, Technical drawings — Indication of dimensions and tolerances Part 1: General principles ISO 129-4, Technical product documentation (TPD) — Indication of dimensions and tolerances — Part 4: Dimensioning of shipbuilding drawings ISO 5261:1995, Technical drawings — Simplified representation of bars and profile sections ISO 657-1. Hot-rolled steel sections — Part 1: Equal-leg angles — Dimensions ISO 657-2, Hot-rolled steel sections — Part 2: Unequal-leg angles — Dimensions ISO 657-16, Hot-rolled steel sections — Part 16: Sloping flange column sections (metric series) — Dimensions and sectional properties ISO 657-18, Hot-rolled steel sections — Part 18: L sections for shipbuilding (metric series) Dimensions, sectional properties and tolerances ISO 657-21, Hot-rolled steel sections — Part 21: T-sections with equal depth and flange width — Dimensions ISO 10209, Technical product documentation — Vocabulary — Terms…