BS ISO 6953-1:2015 pdf free.Pneumatic fluid power – Compressed air pressure regulators and filter-regulators Part 1: Main characteristics to be included in literature from suppliers and product- marking requirements. This part of Iso 6953 specifies which characteristics of compressed air pressure regulators are to be included in literature from their suppliers. It also applies to filter-regulators. This part of ISO 6953 applies to — manually controlled direct operated types (with or without relieving mechanism), — manually controlled internal pilot operating types (e.g. nozzle flapper), and — external pilot operated types. In addition, it specifies the product marking requirements for pressure regulators and filter-regulators. This part of ISO 6953 is applicable to compressed air pressure regulators with a rated inlet pressure of up to 2 500 kPa (25 bar) and an outlet adjustment pressure of up to 1 600 kPa (16 bar); and to filter-regulators with rated inlet and outlet pressures of up to 1 600 kPa (16 bar), in which the major contaminants are removed by mechanical means. NOTE I I bar = 0,1 MPa = 105 Pa; I MPa = I N/mmZ. The rated pressure should be selected from the preferred pressures listed in ISO 2944. NOTE 2 The…

BS ISO 6432:2015 pdf free.Pneumatic fluid power一 Single rod cylinders, 1 000 kPa (10 bar) series, bores from 8mmto25mm一Basicand mounting dimensions. BS ISO 6432 establishes a metric series of mounting dimensions required for interchangeability of commonly used pneumatic cylinders for a maximum working pressure of 1 000 kPa (10 bar). NOTF This International Standard allows manufacturers freedom of design in metric cylinders and does not restrict technical development but provides basic guidelines. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 3320, Fluid power systems and components — Cylinder bores and piston rod diameters and area ratios — Metric series ISO 4393, Fluid power systems and components — Cylinders — Basic series of piston strokes ISO 4395, Fluid power systems and components — Cylinder piston rod end types and dimensions ISO 5598, Fluid power systems and components — Vocabulary ISO 6099, Fluid power systems and components — Cylinders — Identification code for mounting dimensions and mounting types ISO 16030, Pneumatic fluid power —…