ISO 13006-2012 pdf free download.Ceramic tiles – Definitions, classification, characteristics and marking. ISO 13006 defines terms and establishes classifications, characteristics and marking requirements for ceramic tiles of the best commercial quality (first quality). This International Standard is not applicable to tiles made by other than normal processes of extrusion or dry pressing. It is not applicable to decorative accessories or trim such as edges, corners, skirting, capping, coves, beads, steps, curved tiles and other accessory pieces or mosaics (i.e. any piece that can fit into an area of 49 cm2). NOTE ISO 10545 (all parts) describes the test procedures required to determine the product characteristics listed in this International Standard. ISO 10545 is divided into 16 parts, each describing a specific test procedure or related matter. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 1006, Building construction — Modular coordination — Basic module ISO 10545-1, Ceramic tiles — Part 1: Sampling and basis for acceptance ISO 10545-2, Ceramic tiles — Part 2: Determination of dimensions and surface quality ISO 10545-3,…

ISO 13007-2-2013 pdf free.Ceramic tiles – Grouts and adhesives – Part 2: Test methods for adhesives. This part of Iso 13007 describes the methods for determining the characteristics for adhesives used in the installation of ceramic tiles. The following test methods are described: — determination of open time (41); — determination of slip (42); — determination of shear adhesion strength (4); — determination of tensile adhesion strength (4A); — determination of transverse deformation (45). 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 13006, Ceramic tiles — Definitions, classification, characteristics and marking ISO 13007-1, Ceramic tiles — Grouts and adhesives — Part 1: Terms, definitions and specifications for adhesives 3 General test conditions and procedures 3.1 Sampling A representative sample of at least 2 kg shall be used. 3.2 Test conditions Standard conditions shall be (23 ± 2) °C and (50 ± 5) % relative humidity and the speed of air in the testing area shall be less than 0,2 m/s. Other test…

BS ISO 13006:2018 pdf free.Ceramic tiles – Definitions, classification, characteristics and marking. 6 Sampling and basis for acceptance The sampling and basis for acceptance shall be in accordance with that presented in ISO 10545-1. 7 Requirements Dimensional and surface quality requirements and physical and chemical properties shall be as given in the relevant/specific annex, of Annexes A to Hand Annexes jto M. for each tile class. NOTE Annexes I. Q and Q are intentionally left blank. This is as a convenience to producers in order to avoid changes to packaging and related costs. In addition, at the time of publication, the market o[Fers consumers various products identified by the maLching annex headings of this document. 8 Marking and specifications 8.1 Marking Tiles and/or their packaging are required to bear the following marking: a) manufacturer’s mark and/or trademark and the country where the tile was manufactured (i.e. country of origin, as determined by the relevant international regulation); b) indication of first quality; c) type of tile and reference to the appropriate group and/or annex of Annexes A to Hand Annexes Ito M covering the specific group of tile; d) nominal and work sizes, and “M” if modular; e) nature of the…