ISO 22034-2-2016 pdf free.Steel wire and wire products一 Part 2:Tolerances on wire dimensions. This part of ISO 22034 specifies the tolerances on the diameter of round wire and, where applicable, on the length of round wire cut to length, for bright (i.e. uncoated) steel wire, metallic-coated steel wire and non-metallic-coated steel wire. This part of ISO 22034 applies to round wires in the diameter range 0,050 mm to 25,00 mm. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 6929, Steel products — Vocabulary 3 Terms and definitions For the purposes of this document, the terms and definitions given in ISO 6929 and the following apply. 3.1 wire product of constant cross section along its length, obtained by drawing a cold wire rod through a reducing die or passing it under pressure between rollers and rewinding the drawn product Note Ito entry: Wire can be supplied with a metallic or non-metallic coating, or with both, or without a coating. 3.2 cut length straightened…