AS 5236.1:2021 pdf free download.Cranes – Limiting and indicating devices Part 1: General (ISO 10245-1 :2008, MOD). This part of ISO 10245 specifies general requirements for limiting and indicating devices for cranes that are applicable to loads and motions, performance and environment. These devices restrict operation and/or provide the operator or other persons with operational information. The specific requirements for the various types of crane are given in the other parts of ISO 10245. It is emphasized that the safe and reliable operation of limiters and indicators depends upon regular inspection and maintenance. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 4306-1, Cranes — Vocabulary — Part 1: General 3 Terms and definitions For the purposes of this document, the terms and definitions given in ISO 4306-1 and the following apply. 3.1 anti-collision device device used to prevent cranes or parts of cranes from colliding with a fixed load-lifting attachment when they are manoeuvred simultaneously in the same space Note 1 to entry: A working space limiter may perform the…

AS 5235.1:2021 pdf free.Cranes – Information labels Part 1: General (ISO 9942-1:2015, MOD). This part of ISO 9942 specifies the minimum requirements for labels for the identification (marking) and the operation of cranes. 2 ldentification data 2.1 Manufacturer’s data As a minimum, the fllowing information shall figure permanently on every crane: name of the supplier; name of the manufacturer; year of manufacture; serial number; model. 2.2 Loading data Information on the maximum loadings (capacities) shall figure permanently on the crane and be easily legible. This information is also required to avoid overloading; see the other parts of ISO 9942. 3 Information on operation of the crane by the crane operator 3.1 Control installations and indicating devices The information shall be attached where it is easily visible. Further information shall be available in the product-specific standards. 3.2 Tasks of the crane operator Information relating to the tasks of the crane operator on or near the control installations of cranes shall include information about his tasks prior to, during and after crane operation. This shall be in the form of a permanently attached label in the cab, or at the operator’s station if there is no control platform.If there is no control…

ISO 4302:2016 pdf free download.Cranes Wind load assessment Appareils de levage a charge suspen due — Evaluation des charges dues au vent. This ISO 4302 specifies the assessment of wind loads on cranes. It establishes general methods for calculating wind loads (for in-service and out-of-service conditions), which are included in the load combinations stated in Iso 8686-1 and used for proofs of competence such as those given in ISO 20332 for the structural components of cranes. It provides a simplified method of calculation and assumes that — the wind may blow horizontally from any direction, — the wind blows at a constant speed, — there is a static reaction to the wind load applied to the crane structure. It includes built-in allowances for the effects of gusting (fluctuation in wind speed) and for dynamic response. It gives guidance on when to secure the crane for out-of-service conditions. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 8686-1:2012, Cranes — Design principles for loads…