BS EN ISO 15976:2002 pdf download.Closed end blind rivets with break pull mandrel and protruding head一 St/St. BS EN ISO 15976 specifies dimensional and mechanical characteristics and application data for closed end blind rivets with break pull mandrel and protruding head, with a steel body (St) and an steel mandrel (St) and with nominal diameters, d. from 3,2 mm up to and including 6.4 mm. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. ISO 3269:2000, Fasteners — Acceptance inspection ISO 4042:1999, Fasteners — Electroplated coatings ISO 4520:1981, Chromate conversion coatings of electroplated zinc and cadmium coatings ISO 14588:2000, Blind rivets — Terminology and definitions ISO 14589:2000, Blind rivets — Mechanical testing 3 Dimensions 3.1 General Symbols and designations of…