ISO 22400-1-2014 pdf free.Automation systems and integration – Key performance  indicators (KPIs) for manufacturing operations management一 Part 1: Overview, concepts and terminology. The motivation for using KPIs in the MOM domain starts with a description of the value creation processes (see Clause A.2). An enterprise is described by three hierarchical models: — physical asset; — functional; — equipment. The functional and the equipment hierarchy models are of importance in ISO 22400. The KPls in ISO 22400 are limited to the MOM domain (see Clause AA). Selection of KPIs depends on the production methodology that is used by the enterprise (see Clause A.5). KPIs in the MOM domain identify and achieve improvement targets based on actionable information (see Clauses A.6 and Al). 4.2 Criteria for KPIs A good KPI has certain criteria which ensure its usefulness in achieving various goals in the manufacturing operation. The criteria are listed below, along with the process for performing each individual measurement. a) Aligned: the KPI is aligned to the degree to which the KPI affects change in relevant higher-level KPIs, where alignment implies a high ratio of the percent improvement (assuming positive impact) in important higher-level metrics to the percent improvement in a KPI…

ISO 14649-14-2013 pdf download.Automation systems and integration一Physical device control – Data model for computerized numerical controllers一 Part 14: Process data for sink electrical discharge machining (sink-EDM). This part of ISO 14649 specifies the technology-specific data element needed as process data for sinkEDM. Together with the general process data described in ISO 14649-10, it describes the interface between computerized numerical controller and the programming system (i.e. CAM system or shop- floor programming system) for sink-EDM. It can be used for sink-EDM operations on this kind of machine. The scope of this part of ISO 14649 does not include tools for any other technologies (e.g. turning, grinding). Tools for these technologies are described in other parts of ISO 14649. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 14649-10, Industrial automation systems and integration — Physical device control — Data model for computerized numerical controllers — Part 10: General process data 3 Terms and definitions For the purposes of this document, the terms and definitions…