ISO 6787-2018 pdf free.Assembly tools for screws and nuts – Adjustable wrenches. This document specifies the dimensions of adjustable wrenches and the admissible clearance of the adjustable jaw. It also specifies test conditions to test the suitability of tool performance. NOTE The wrenches covered by this document are the ones identified in ISO 1703:2005 under reference number 11 01 040. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 1711-1, Assembly tools for screws and nuts — Technical specifications — Part 1: Handoperated wrenches and sockets 3 Terms and definitions No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https://www.iso.org/obp — IEC Electropedia: available at https://www.electropedia.org/ 4 Dimensions The dimensions are given in Table 1. Figure 1 shows only an example and should not influence the design of the wrench. 5 Technical specifications 5.1 Clearance of adjustable…