ISO 16130-2015 pdf free.Aerospace series一Dynamic testing of the locking behaviour of bolted connections under transverse loading conditions (vibration test). ISO 16130 applies to the dynamic testing of the locking behaviour of bolted connections in order to investigate the self-loosening behaviour of fasteners for aerospace applications and is mainly intended for development work. As test apparatuses are different (e.g. stiffness distribution), testing In accordance with this International Standard, therefore, does not allow an absolute statement to be made on the locking behaviour of bolted assemblies under service loads. Thus, the objective of this test is a comparative evaluation of locking elements under defined test conditions. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 16047, Fasteners — Torque/clamp force testing 3 Terms and definitions For the purposes of this document, the terms and definitions given in ISO 16047 and the following apply. 3.1 clamp force axial tension acting on the bolt shank or compression acting on the clamped member (SOURCE: ISO 16047:2005, 3.1; modified…

BS ISO 8278:2016 pdf free.Aerospace series – Hydraulic, pressure compensated, variable delivery pumps – General requirements. This International Standard establishes the general requirements for pressure compensated, variable delivery hydraulic pumps, suitable for use in aircraft hydraulic systems at pressures up to 35 000 kPa (5 000 psi). This International Standard is to be used in conjunction with detail specifications that is particular to each application. 2 Normative references The following documents, in whole or in part, are normatively referenced In this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 2093, Electroplated coatings of tin — Specification and test methods ISO 2669, Environmental tests for aircraft equipment — Steady-state acceleration ISO 2671, Environmental tests for aircraft equipment — Part 3.4 : Acoustic vibration ISO 2685, Aircraft — Environmental test procedure for airborne equipment — Resistance to fire in des:qnated fire zones ISO 3323, Aircraft — Hydraulic components — Marking to indicate fluid for which component is approved ISO 3601-1:2012, Fluid power systems — 0-rings — Part 1: Inside diameters, cross-sections, tolerances and designation codes ISO 7137, Aircraft — Environmental…