AS ISO 7546:2021 pdf free.Earth-moving machinery一Loader and front loading excavator buckets一Volumetric ratings.
AS ISO 7546 specifies a procedure for approximating the volume of typical materials contained in the bucket of front end loaders and excavators with front loading bucket. The volume ratings are based on the inside dimensions of the bucket and representative volumes on top of the bucket.
1.2 The method employs the technique of dividing the complex shape of the material in the bucket into simple geometric forms to allow volume calculations of different bucket configurations.
1.3 The rating method is intended to provide a consistent means of comparing bucket capacities. It is not intended to define actual capacities that might be observed in any specific application.
2 References
ISO 7131, Earth-moving machinery — Loaders — Terminology
ISO 7135, Earth-moving machinery — Excavators — Terminology
3 Restrictions and limitations
3.1 The effect on volumes of local discontinuities such as bucket teeth, tooth adapters, and gussets shall be ignored.
3.2 Grated or slotted back sheets attached to the bucket to protect the machine or operator from material that might spill over the back of the bucket shall not be included in the capacity calculations.
Solid extended back sheets providing the same function may be included in the capacity calculations only if they are an integral part of the bucket.
3.3 Only buckets with an X/Y ratio greater than 12 shall be considered by the rating method(s). (See figure 2.)
4 Definitions and symbols
4.1 bucket component See figure 1 and ISO 7131 and 7135.
4.2 strike plane Horizontal plane across the width of the bucket from the cutting edge to the back sheet. (See clause 5 for different bucket shapes.)
4.3 struck volume Vs Volume which lies beneath the strike plane.
4.4 top volume Vτ Volume of material, a 2:1 slope, which lies on top of the strike plane.
4.5 rated bucket volume VR Rated bucket capacity.This capacity is calculated by adding the struck and top volumes: VR= Vs+ VT.AS ISO 7546 pdf free download.
Tags: Earth-moving machinery
-
AS/NZS 60335.2.11:2020 pdf free download.Household and similar electrical appliances- Safety Part 2.11: Particular requirements for tumble dryers (IEC 60335-2-11 Ed 8, MOD). 7.10 Addition: If the off position is only indicated by letters, the word “off” shall be used. 7.12 Addition: The instructions shall state — the maximum mass of dry textile material in kilograms to be used in the appliance; — that the tumble dryer is not to be used if industrial chemicals have been used for cleaning; — that the lint trap has to be cleaned frequently, if applicable; — that lint must not to be allowed to accumulate around the tumble dryer (not applicable for appliances intended to be vented to the exterior of the building); — that adequate ventilation has to be provided to avoid the back flow of gases into the room from appliances burning other fuels, including open fires (this instruction is not required if the tumble dryer discharges the air into the room). If symbol ISO 7000-0790 (2004-01) is used, its meaning shall be explained. The instructions shall include the substance of the following. — Do not dry unwashed items in the tumble dryer. — Items that have been soiled with substances such…
-
AS ISO 37100:2020 pdf free download.Sustainable cities and communities 一Vocabulary. 1 Scope This document defines terms relating to sustainable development in communities, smart community infrastructure and related subjects. 2 Normative references There are no normative references in this document. 3 Terms and definitions ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at http://www.iso.orgJobp — IEC Electropedia: available at httwwwe1e1ropetha.orgJ 3.1 Terms relating to sustainable development, resilience and smartness 3.1.1 sustainability state of the global system, including environmental, social and economic aspects, in which the needs of the present are met without compromising the ability of future generations to meet their own needs Note I to entry: The environmental, social and economic aspects interact, are interdependent and are often referred to as the three dimensions of sustainability. Note 2 to entry: Sustainability is the goal of sustainable development. [SOURCE: ISO Guide 82:2014, 3.1] 3.1.2 sustainable development development that meets the environmental, social and economic needs of the present without compromising the ability of future generations to meet their own needs Note ito entry: Derived from the Brundtland Report. Note 2 to entry: The Aalborg Charter provides further information on…
-
AS ISO 37104:2020 pdf free.Sustainable cities and communities – Transforming our cities一Guidance for practical local implementation of AS IsO 37101. This document provides guidance on how to implement and maintain a management system for sustainable development based on ISO 37101 principles, specifically in the context of cities, but applicable to other forms of settlement. This document: — provides guidance for practical implementation ofa managernentsystem for sustainable development in cities and other settlements, based on ISO 37101; — establishes a methodological framework forthe systematic evaluation ofthe sustainable development schemes and achievements in the city or other settlements, based on the cross-analysis of the six purposes of sustainability and the 12 areas of action of ISO 37101; — illustrates how other International Standards can be used to support successful implementation of ISO 37101, including, in particular, ISO 37120 (which recommends a suite of city indicators mapped against the six purposes of ISO 37101) and ISO 37106 (which provides practical guidance on how to implement joined-up delivery and innovation across organizational boundaries within the city or settlement). This document is intended for organizing bodies, decision-makers, executive officers and managers in cities — usually, in the first instance, the relevant local governments. This document…